Liquid Inoculator
The ADS SEED TREATER is
mounted on a bracket designed to mount on an ADS BULK SEED BUGGY, but it
can be used to apply inoculant on seed being handled with almost any
equipment. Fittings on the discharge hose are quick release. The
discharge hose contains a shut-off valve on the bottom of the tank and a
strainer inside the hose disconnect. The flow is adjusted with a
"George Fisher" valve mounted beside the pump. If you are using an ADS
BULK SEED BUGGY, there is no assembly required. If you are using the
seed treater with other equipment, you must mount the bracket with the
supplied hardware. The ADS SEED TREATER comes with a power switch
mounted next to the pump. When using the seed treater with an ADS BULK
SEED BUGGY, there is an additional switch on the auger motor throttle.
This turns the seed treater on as the tender auger is put into
operation. |
|
Dry Inoculator
(for Talc & Graphite)
The ADS Dry Seed Inoculator
System is driven by a low RPM, high torque gearbox and 12volt DC motor.
The metering gate and special designed blade adjusts the flow rate for
varied products and application rates. Also, the blade design helps
eliminate product bridging. The ADS Dry Seed Inoculator System
accurately dispenses seed treatment onto the seed as it moves through
the handling system.
The ADS Dry Seed Inoculator System easily mounts to the ADS Bulk Seed
Buggy or almost any handling equipment with the included mounting
bracket. It provides hands-free operation with the automatic
on/off switch that starts the inoculator motor when the tender auger is
put into operation. It comes with a convenient 3-way switch and it
connects to battery power with 50' of wiring. The wiring harness
has weather tight plugs. Direct-wired models are available.
|
|